Používateľská príručka nástroja na resetovanie systému TPMS EL-50448
Model: EL-50448 (OEC-T5)
Značka: TPMS
1. Úvod
The EL-50448 TPMS Reset Tool is designed to assist in the re-learn procedure for Tire Pressure Monitoring Systems (TPMS) in most GM vehicles equipped with a 315 or 433 MHz TPMS. This procedure is necessary after tire rotations, Remote Control Door Lock Receiver Module replacement, or Tire Pressure Sensor replacement to ensure the system functions correctly.
The tool facilitates the reading of tire pressure sensor information, allowing the Body Control Module to record the ID information of each sensor position. It is a compact and portable device, universal for most cars, and features a diagnostic sensing function.
Obrázok 1.1: Predná a zadná strana view of the EL-50448 TPMS Reset Tool.
Účel: To perform the "Sensor Re-Learn Procedure" for GM vehicle TPMS.
Kompatibilita: Works on GM models equipped with 315 or 433 MHz TPMS, including 2014 GM models and later.
Vlastnosti: Diagnostic sensing function, compact and portable design.
Poznámka: The package does not include the charger and battery. Please purchase them separately.
2. Nastavenie
Before using the EL-50448 TPMS Reset Tool, ensure it is properly powered. The tool requires a 9V battery (not included). Follow these steps to install the battery:
Locate the battery compartment cover on the back of the tool.
Posuňte kryt smerom nadol, aby ste otvorili priehradku.
Insert a new 9V battery, ensuring the polarity is correct.
Zasuňte kryt priehradky na batérie späť na miesto, kým bezpečne nezacvakne.
Figure 2.1: Battery compartment on the back of the tool.
Once the battery is installed, the tool is ready for operation.
3. Návod na obsluhu
To perform the tire pressure sensor re-learn procedure, follow these steps carefully:
Step 1: Enter Learning Mode
Set the vehicle's gearshift lever to "P" (Park).
Put the ignition switch to "ON" (Engine Off, Ignition On).
Navigate to the tire pressure display interface using the Driver Information Center (DIC).
The DIC should display "Press Set / Ctrl to re-learn".
Press the "Set / Ctrl" button on your vehicle's controls.
The vehicle's turn signal will light for 3 seconds, and the horn will beep twice, indicating that the vehicle has entered the learning mode.
Step 2: Read Tire Pressure Sensor Information (Front-Left Wheel)
Begin the re-learn process starting with the front-left wheel.
Hold the EL-50448 tool's antenna up against the valve core position of the front-left tire. Ensure it is close to the rim of the tire sidewall.
Press the activation button on the EL-50448 tool to start the reading process.
A single horn beep from the vehicle indicates that the tire pressure sensor information has been successfully read.
Figure 3.1: Positioning the tool near the tire valve for activation.
Figure 3.2: The tool activates the individual TPMS sensor with a single button press.
Step 3: Read Other Tire Pressure Information
Continue the process for the remaining tires in the following order:
Front-Right wheel
Rear-Right wheel
Rear-Left wheel
Use the same method as described in Step 2 for each wheel. After the last wheel's sensor information is successfully read, the vehicle's turn signals will light for 3 seconds, and the horn will beep twice, indicating that the learning procedure is complete.
Figure 3.3: The tool is held against the tire sidewall near the valve stem.
4. Údržba
Proper maintenance ensures the longevity and optimal performance of your EL-50448 TPMS Reset Tool.
Čistenie: Náradie utrite mäkkou, suchou handričkou. Nepoužívajte abrazívne čistiace prostriedky ani rozpúšťadlá.
Ukladací priestor: Náradie skladujte na chladnom a suchom mieste mimo dosahu priameho slnečného žiarenia a extrémnych teplôt.
Výmena batérie: Replace the 9V battery when the "LOW BAT" indicator light illuminates on the tool. Refer to the "Setup" section for battery installation instructions.
Vyhnite sa kvapkám: Protect the tool from physical shocks and drops, which can damage internal components.
5. Riešenie problémov
If you encounter issues while using the EL-50448 TPMS Reset Tool, refer to the following common problems and solutions:
Problém
Možná príčina
Riešenie
Tool does not activate sensor / No horn beep
Vehicle not in learning mode.
Tool battery is low or dead.
Tool not positioned correctly.
Problém so snímačom.
Ensure vehicle is in TPMS learning mode (refer to Step 1 of Operating Instructions).
Check "LOW BAT" indicator. Replace 9V battery if necessary.
Ensure the tool's antenna is directly against the valve core and close to the rim.
Consult a professional if the sensor is suspected to be faulty.
"LOW BAT" indicator light is on
Batéria je nízka.
Replace the 9V battery immediately. Refer to the "Setup" section.
Nástroj sa nezapína
No battery or incorrect installation.
Chybná batéria.
Ensure a 9V battery is installed correctly with proper polarity.
Vyskúšajte novú 9V batériu.
Figure 5.1: Indicator lights on the EL-50448 tool.
6. Špecifikácie
Atribút
Detail
Číslo modelu
EL-50448 (OEC-T5)
Číslo modelu položky
756029690080
Značka
TPMS
Hmotnosť položky
5 uncí
Rozmery (približne)
153 mm (6.02") x 53 mm (2.09") x 35 mm (1.38")
Zdroj napájania
9V batéria (nie je súčasťou balenia)
Prevádzková frekvencia
315 or 433 MHz (for TPMS sensors)
UPC
669763149045
Výrobca
Amzmall
Dátum prvej dostupnosti
14. septembra 2020
Figure 6.1: Approximate dimensions of the EL-50448 tool.
7. Záruka a podpora
For warranty information, technical support, or any inquiries regarding your EL-50448 TPMS Reset Tool, please contact the manufacturer or seller directly.
Výrobca: Amzmall
General Support Line: 1-888-407-8767 (As seen on product labeling)
Pravidlá vrátenia tovaru: Refer to your purchase platform's return policy (e.g., Amazon's 30-day refund/replacement policy).
Pre prípadné reklamácie si uschovajte doklad o kúpe.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.